This model is used to prevent freezing of
the condenser or evaporator side.
A real device would shut off as well.
This models takes the minimum of the two temperatures evaporator
outlet and condenser inlet. If this minimal temperature falls below
the given lower boundary, the hystereses will trigger an error and cause
the device to switch off.
Assumptions
This block does not check the evaporator inlet or condenser outlet temperatures
because they are assumed to be always higher than the other side.
-
October 2, 2022 by Fabian Wuellhorst:
Adapted based on AixLib implementation (see issue #1576)
-
November 26, 2018 by Fabian Wuellhorst:
First implementation (see issue AixLib #577)
Generated at 2024-12-23T19:25:42Z
by OpenModelicaOpenModelica 1.24.3 using GenerateDoc.mos