.AixLib.ThermalZones.HighOrder.Components.Walls.Wall

Information

Overview

Flexible Model for Inside Walls and Outside Walls.

Concept

The WallSimple model models

• Conduction and convection for a wall (different on the inside surface depending on the surface orientation: vertical wall, floor or ceiling)
• Outside walls may have a window and/ or a door
• Inside walls may have a door

This model uses a HeatStarComb Connector for an easier connection of temperature and radiance inputs.

Assumptions

• Outside walls are represented as complete walls
• Inside walls are modeled as a half of a wall, you need to connect a corresponding second half with the same values
• Door and window got a constant U-value
• No heat storage in doors or window

Have a closer look at the used models to get more information about the assumptions.

Example Results

AixLib.Building.Components.Examples.Walls.InsideWall

• June, 18, 2020 by Fabian Wuellhorst:
  #918: Add short wave connector to pass wall and window parameters.
• June, 18, 2020 by Fabian Wuellhorst:
  #918: Add short wave connector to pass wall and window parameters.
• July 1, 2020 by Konstantina Xanthopoulou:
  #898:Added HeatPort to connect absSolarRadWin properly,
  #882:Rearranged components to only use one wall model.
• April 23, 2020 by Philipp Mehrfeld:
  #752: Mainly add wallType, rearrange components.
• October 12, 2016  by Tobias Blacha:
  Algorithm for HeatConv_inside is now selectable via parameters on upper model level. This closes ticket issue 215
• August 22, 2014  by Ana Constantin:
  Corrected implementation of door also for outside walls. This closes ticket issue 13
• May 19, 2014  by Ana Constantin:
  Formatted documentation appropriately
• May 02, 2013  by Ole Odendahl:
  Formatted documentation appropriately
• June 22, 2012  by Lukas Mencher:
  Outside wall may have a door now, icon adjusted
• Mai 24, 2012  by Ana Constantin:
  Added inside surface orientation
• April, 2012  by Mark Wesseling:
  Implemented.

Contents