This is a special electrical switch used to check whether anything is connected from the outside to the connector n2.
If this is the case, the switch should be in the p-n2 position.
If this is not the case, the switch should be in the p-n1 position.
This commuting switch must be used instead of the corresponding IdealCommutingSwitch model, because Dymola
sets by default the flow of an unconnected terminal to zero. Hence we must not set it to zero once more
externally.
Generated at 2024-05-17T18:15:58Z
by OpenModelicaOpenModelica 1.22.4 using GenerateDoc.mos