packageBaseClasses

Information

This package contains base classes that are used to construct the models in Buildings.Fluid.DXSystems.Cooling.

Contents

Name	Description
ApparatusDewPoint	Calculates air properties at apparatus dew point
ApparatusDryPoint	Calculates air properties at dry coil surface
CapacityWaterCooled	Calculates cooling capacity at given temperature and flow fraction for water source DX coils
Condensation	Calculates rate of condensation
DXCooling	DX cooling coil operation
DryWetSelector	Selects results from dry or wet coil
EssentialParameters	A partial block for essential parameters for cooling DX coils
Evaporation	Model that computes evaporation of water that accumulated on the coil surface
InputPower	Electrical power consumed by the unit
PartialCapacity	Calculates performance curve value at given temperature and mass flow rate
PartialCoilCondition	Partial block for dry and wet coil conditions
PartialCoilInterface	Partial block for DX coil
PartialDXCoil	Partial model for air or water cooled DX cooling coil
PartialDXCoolingCoil	Partial model for DX cooling coil
PartialSurfaceCondition	Partial block for apparatus dew and dry point calculation
PartialWaterCooledDXCoil	Base class for water source DX coils
SensibleHeatRatio	Calculates the sensible heat ratio
SpeedSelect	Selects the lower specified speed ratio for multispeed model
SpeedShift	Interpolates values between speeds
UACp	Calculates UA/Cp of the coil
WetCoil	Calculates wet coil condition
Functions	Package with functions
Examples	Collection of models that illustrate model use and test models