modelFlowJunctionSteadyStateNoPressureDrop

Test model for the three way splitter/mixer model configured as steady-state
Diagram of FlowJunctionSteadyStateNoPressureDropOpen the diagram
▶ Simulate in your browser

Extends from Modelica.Icons.Example (Icon for runnable examples).

Information

This model validates the use of the splitter and mixer model for different flow directions. The example is configured such that the flow changes its direction in each flow leg between t = 0 seconds to t = 100 seconds. The splitter model has been configured as a steady-state model, with no flow resistance.

Components

TypeNameDefaultDescription
Buildings.Fluid.FixedResistances.JunctionsplSplitter
Buildings.Fluid.Sources.MassFlowSource_Tbou1Mass flow boundary condition
Buildings.Fluid.Sources.Boundary_pTbou2Pressure boundary condition
Buildings.Fluid.Sources.MassFlowSource_Tbou3Mass flow boundary condition
Modelica.Blocks.Sources.Rampm1_flowRamp mass flow signal
Modelica.Blocks.Sources.Rampm3_flowRamp mass flow signal
Buildings.Fluid.Sensors.TemperatureTwoPortsenTem1Temperature sensor
Buildings.Fluid.Sensors.TemperatureTwoPortsenTem2Temperature sensor
Buildings.Fluid.Sensors.TemperatureTwoPortsenTem3Temperature sensor

Contents

NameDescription
MediumMedium model

Revisions

  • January 18, 2017, by Michael Wetter:
    Changed spl.m_flow_nominal, boundary condition and enabled sensor dynamics.
    This is for issue 657.
  • October 14, 2016, by Michael Wetter:
    First implementation.
    This is for issue 451.