connectorHeatPort_a

Diagram of HeatPort_aOpen the diagram

Extends from Modelica.Thermal.HeatTransfer.Interfaces.HeatPort (Thermal port for 1-dim. heat transfer).

Information

This connector extends the Modelica HeatPort Interface and is used for 1-dimensional heat flow between components. The variables in the connector are:

   T       Temperature in [Kelvin].
   Q_flow  Heat flow rate in [Watt].

According to the Modelica sign convention, a positive heat flow rate Q_flow is considered to flow into a component. This convention has to be used whenever this connector is used in a model class.

 

For detailed model documentation please consult the html-documentation shipped with ClaRa.

 


Authorship and Copyright Statement for original (initial) Contribution

Author:

DYNCAP/DYNSTART development team, Copyright © 2011-2024.

References:

For references please consult the html-documentation shipped with ClaRa.

Remarks:

This component was developed by ClaRa development team under the 3-clause BSD License.

Acknowledgements:

ClaRa originated from the collaborative research projects DYNCAP and DYNSTART. Both research projects were supported by the German Federal Ministry for Economic Affairs and Energy (FKZ 03ET2009 and FKZ 03ET7060).

CLA:

The author(s) have agreed to ClaRa CLA, version 1.0. See https://claralib.com/pdf/CLA.pdf

By agreeing to ClaRa CLA, version 1.0 the author has granted the ClaRa development team a permanent right to use and modify his initial contribution as well as to publish it or its modified versions under the 3-clause BSD License.

The ClaRa development team consists of the following partners:

TLK-Thermo GmbH (Braunschweig, Germany)

XRG Simulation GmbH (Hamburg, Germany).

Components

TypeNameDefaultDescription
SI.TemperatureT (from HeatPort)Port temperature
SI.HeatFlowRateQ_flow (from HeatPort)Heat flow rate (positive if flowing from outside into the component)

Revisions

For revisions please consult the html-documentation shipped with ClaRa.