| Boolean | showExpertSummary | simCenter.showExpertSummary | |Summary and Visualisation||True, if expert summary should be applied |
| Boolean | preciseTwoPhase | true | |Expert Stettings||True, if two-phase transients should be calculated precisely |
| Fundamental Definitions |
| TILMedia.VLEFluid.Types.BaseVLEFluid | medium | simCenter.fluid1 | Medium in the component |
| Integer | N_wall | 3 | Number of radial elements of the wall |
| Geometry |
| Modelica.Units.SI.Length | diameter_o | 0.5 | Diameter of the component |
| Modelica.Units.SI.Length | diameter_i | 0.45 | Diameter of the component |
| Modelica.Units.SI.Length | length | 3 | Length of the component |
| Integer | N | 1 | Number of identical injectors in parallel |
| Nominal Values |
| Modelica.Units.SI.Pressure | p_nom | 1e5 | Nominal pressure |
| Modelica.Units.SI.SpecificEnthalpy | h_nom_Main | 3000e3 | Nominal specific enthalpy |
| Modelica.Units.SI.SpecificEnthalpy | h_nom_Spray | 1000e3 | Nominal specific enthalpy |
| Modelica.Units.SI.MassFlowRate | m_flow_nom_main | 300 | Nominal mass flow rates at inlet |
| Modelica.Units.SI.Pressure | Delta_p_nom | 1000 | Nominal pressure loss |
| Modelica.Units.SI.MassFlowRate | m_flow_nom_spray | 10 | Nominal injection mass flow rate |
| Modelica.Units.SI.Pressure | Delta_p_nozzle | 1000 | Nominal pressure loss of spray valve |
| Initialisation |
| Modelica.Units.SI.SpecificEnthalpy | h_start_Main | 3000e3 | Initial specific enthalpy at main inlet |
| Modelica.Units.SI.SpecificEnthalpy | h_start_Spray | 1000e3 | Initial specific enthalpy at main inlet |
| Modelica.Units.SI.Pressure | p_start | 1e5 | Start value of sytsem pressure |
| Integer | initOption | 0 | Type of initialisation at tube side |
| Boolean | useHomotopy | simCenter.useHomotopy | True, if homotopy method is used during initialisation |
| Summary and Visualisation |
| Boolean | showData | false | True, if a data port containing p,T,h,s,m_flow shall be shown, else false |
Material