| Modelica.Units.SI.SpecificEnthalpy | h_start_main | 3000e3 | |Initialisation|Fluid|Initial specific enthalpy of main phase |
| Modelica.Units.SI.SpecificEnthalpy | h_start_spray | h_start_main - 100 | |Initialisation|Fluid|Initial specific enthalpy of spray phase |
| Modelica.Units.SI.Pressure | p_start | 1e5 | |Initialisation|Fluid|Start value of sytsem pressure |
| Real | y_start | 0.05 | |Initialisation|Fluid|Start value for ratio spray volume to total volume |
| Modelica.Units.SI.Temperature[N_wall] | T_wall_start | ones(N_wall)*TILMedia.VLEFluid.Functions.temperature_phxi(medium, p_start, h_start_main) | |Initialisation|Wall|Start values of wall temperature |
| ClaRa.Basics.Choices.Init | initWall | ClaRa.Basics.Choices.Init.noInit | |Initialisation|Wall|Initialisation option of wall |
| Boolean | useHomotopy | simCenter.useHomotopy | |Initialisation||True, if homotopy method is used during initialisation |
| ClaRa.Basics.Units.Time | Tau_cond | 0.03 | |Expert Settings|Mixing Model|Time constant of condensation |
| ClaRa.Basics.Units.Time | Tau_evap | Tau_cond | |Expert Settings|Mixing Model|Time constant of evaporation |
| ClaRa.Basics.Units.CoefficientOfHeatTransfer | alpha_ph | 50000 | |Expert Settings|Mixing Model|HTC of the phase border |
| ClaRa.Basics.Units.Area | A_phaseBorder | 10 | |Expert Settings|Mixing Model|Heat transfer area at phase border |
| Real | exp_HT_phases | 0 | |Expert Settings|Mixing Model|Exponent for volume dependency on inter phase HT |
| Integer | N_wall | 3 | |Expert Settings|Wall|Number of radial elements of the wall |
| ClaRa.Basics.Units.VolumeFraction[2] | eps_mix | {0.2, 0.8} | |Expert Settings|Mixing Model|Volume fraction V_1/V_tot of min/max mixed outlet |
| Boolean | showExpertSummary | simCenter.showExpertSummary | |Summary and Visualisation||True, if expert summary should be applied |
| Boolean | showData | false | |Summary and Visualisation||True, if a data port containing p,T,h,s,m_flow shall be shown, else false |
| Fundamental Definitions |
| TILMedia.VLEFluid.Types.BaseVLEFluid | medium | simCenter.fluid1 | Medium in the component |
| Geometry |
| Modelica.Units.SI.Length | diameter_o | 0.5 | Diameter of the component |
| Modelica.Units.SI.Length | diameter_i | 0.45 | Diameter of the component |
| Modelica.Units.SI.Length | length | 3 | Length of the component |
| Nominal Values |
| Modelica.Units.SI.Pressure | p_nom | 1e5 | Nominal pressure |
| Modelica.Units.SI.MassFlowRate | m_flow_nom_main | 10 | Nominal mass flow rates at inlet |
| Initialisation › Fluid |
| Integer | initOptionFluid | 211 | Type of initialisation of fluid |
Material
PressureLoss