modelPartial_Ctrl_Heating
Partial for a heating control algorithm without TES
Parameters
| Type | Name | Default | Description |
|---|---|---|---|
| Modelica.Units.SI.Temperature | TRoo_nominal | 273.15 + 21 | Room temperature at nominal condition |
| Modelica.Units.SI.Temperature | TSupNom | Nominal heating curve supply temperature | |
| Modelica.Units.SI.TemperatureDifference | dTSupRetNom | 10 | Nominal difference between supply and return water temperatures |
| Modelica.Units.SI.TemperatureDifference | dTHeaterSet | 2 | Difference between heating curve setpoint and heater setpoint |
| Modelica.Units.SI.Time | timeFilter | 43200 | Time constant for filter on ambient temperature |
| Modelica.Units.SI.Temperature | TSupMin | 273.15 + 30 | Minimum supply temperature if enabled |
| Boolean | minSup | true | true to limit the supply temperature on the lower side |
| Modelica.Units.SI.TemperatureDifference | dTOutHeaBal | 0 | Offset for heating curve |
| Modelica.Units.SI.Temperature | TOut_nominal | 273.15 - 8 | Outside temperature |
| Modelica.Units.SI.TemperatureDifference | corFac_val | 0 | correction term for TSet of the heating curve |
Connectors
| Type | Name | Default | Description |
|---|---|---|---|
| Modelica.Blocks.Interfaces.RealOutput | THeaterSet | Heat pump set temperature | |
| Modelica.Blocks.Interfaces.RealOutput | THeaCur | Heating curve setpoint | |
| Modelica.Blocks.Interfaces.RealInput | TRoo_in1 | Room air temperature set point |
Components
| Type | Name | Default | Description |
|---|---|---|---|
| HeatingCurves.HeatingCurveFilter | heatingCurve | ||
| IDEAS.BoundaryConditions.SimInfoManager | sim | ||
| Modelica.Blocks.Sources.RealExpression | realExpression | ||
| Modelica.Blocks.Sources.RealExpression | realExpression2 | ||
| Modelica.Blocks.Sources.RealExpression | corHeaCur | Correction term on the heating curve |
Revisions
-
February 4, 2025, by Jelger Jansen:
AddedModelica.Units.to one or multiple parameter(s) due to the removal ofimportin IDEAS/package.mo. See #1415 .