.IDEAS.Fluid.Movers.Validation

Information

This package contains validation models for the classes in IDEAS.Fluid.Movers.

Note that most validation models contain simple input data which may not be realistic, but for which the correct output can be obtained through an analytic solution. The examples plot various outputs, which have been verified against these solutions. These model outputs are stored as reference data and used for continuous validation whenever models in the library change.

Contents

NameDescription
 ControlledFlowMachineFans with different control signals as input
 ControlledFlowMachineDynamicFans with different control signals as input and a dynamic speed signal
 FlowControlled_dpFan with zero mass flow rate and head as input
 FlowControlled_dpSystemDemonstration of the use of prescribedPressure
 FlowControlled_m_flowFan with zero mass flow rate and mass flow rate as input
 PowerExactPower calculation comparison among three mover types, using exact power computation for m_flow and dp
 PowerSimplifiedPower calculation comparison among three mover types, using simplified power computation for m_flow and dp
 PumpCurveConstructionValidation model that tests that the pump curve is properly extrapolated to V=0 and dp=0
 PumpCurveDerivativesCheck for monotoneously increasing pump curve relations between Nrpm, dp and m_flow
 Pump_Nrpm_stratosModel validation using a Wilo Stratos 80/1-12 pump
 Pump_stratosStratos pumps with speed as input
 SpeedControlled_NrpmFan with zero mass flow rate and speed as input
 SpeedControlled_yFan with zero mass flow rate and control signal y as input
 SpeedControlled_y_linearPump with linear characteristic for pressure vs. flow rate
 BaseClassesPackage with base classes for IDEAS.Fluid.Movers.Validation

Generated at 2024-12-03T19:25:34Z by OpenModelicaOpenModelica 1.24.2 using GenerateDoc.mos