.IDEAS.Fluid.Sensors.MassFraction

Information

This model outputs the mass fraction of the fluid connected to its port. The sensor is ideal, i.e., it does not influence the fluid.

To measure mass fraction in a duct or pipe, use IDEAS.Fluid.Sensors.MassFractionTwoPort rather than this sensor. Read the IDEAS.Fluid.Sensors.UsersGuide prior to using this model to see about potential numerical problems if this sensor is used incorrectly in a system model.

Revisions

• September 21, 2020, by Michael Wetter:
  Introduced parameter warnAboutOnePortConnection and updated documentation.
  This is for #1399.
• February 25, 2020, by Michael Wetter:
  Changed icon to display its operating state.
  This is for #1294.
• January 26, 2016, by Michael Wetter:
  Corrected wrong assignment XiVec[Medium.nXi](quantity=Medium.extraPropertiesNames) to XiVec[Medium.nXi](quantity=Medium.substanceNames[1:Medium.nXi]).
  Changed unit of output signal from 1 to kg/kg to indicate that it is a mass fraction, and declared the assignment final.
• September 10, 2013, by Michael Wetter:
  Changed min and max values for output signals to allow for numerical approximation error without violating these bounds.
  Changed medium declaration in the extends statement to replaceable to avoid a translation error in OpenModelica.
• August 31, 2013, by Michael Wetter:
  Revised model to use base class IDEAS.Fluid.BaseClasses.IndexMassFraction.
• February 22, by Michael Wetter:
  Improved the code that searches for the index of the substance in the medium model.
• April 7, 2009 by Michael Wetter:
  First implementation. Implementation is based on enthalpy sensor of Modelica.Fluid.