modelPartialFittingTest
Partial model for fitting component test
Information
Switch to the diagram or equation layer to see the model of a Modelica.Fluid bend using Fluid.Dissipation pressure loss calculations .
This model executes pressure loss calculations out of the Fluid.Dissipation library for a bend of an incompressible and single-phase fluid flow considering surface roughness. Both the compressible case, where the mass flow rate (M_FLOW) is calculated in dependence of a known pressure loss (dp) and the incompressible case, where the pressure loss (DP) is calculated in dependence of a known mass flow rate (m_flow) are modelled.
Components
| Type | Name | Default | Description |
|---|---|---|---|
| Modelica.Fluid.System | system | ||
| Modelica.Fluid.Sources.Boundary_pT | source_left | ||
| Modelica.Fluid.Sources.Boundary_pT | source_right | ||
| Modelica.Blocks.Sources.Ramp | ramp | ||
| Modelica.Fluid.Sources.MassFlowSource_T | boundary | ||
| Modelica.Fluid.Sensors.MassFlowRate | sensor | ||
| FittingComponent | fitting1 | ||
| FittingComponent | fitting2 |
Contents
| Name | Description |
|---|---|
 Medium | |
 FittingComponent |