modelBus_2Ph
Two-phase bus
Extends from ThreePhaseComponent (Partial model for inheritance of single-phase base power based on three-phase system base power.).
Information
This is a two-phase bus model.
A bus represents a node in a power system. Therefore, this model can be used to verify voltage magnitude and angle in the two-phase nodes of the system.
Although it is not necessary, it is extremely recommended to connect one bus model between two other two-phase models.
Please, check if this bus model is the appropriate one for your system. For the connection of three- or single-phase models, three- or single-phase buses might be a better fit.
Parameters
| Type | Name | Default | Description |
|---|---|---|---|
| Power flow data | |||
| Types.ApparentPower | S_b (from ThreePhaseComponent) | SysData.S_b | System base |
| Types.ApparentPower | S_p (from ThreePhaseComponent) | SysData.S_b/3 | Phase base |
| Types.PerUnit | V_1 | 1 | Voltage magnitude for phase 1 |
| Types.PerUnit | V_2 | 1 | Voltage magnitude for phase 2 |
| Types.Angle | angle_1 | 0 | Voltage angle for phase 1 |
| Types.Angle | angle_2 | -2*C.pi/3 | Voltage angle for phase 2 |
Connectors
| Type | Name | Default | Description |
|---|---|---|---|
| OpenIPSL.Interfaces.PwPin | p1 | ||
| OpenIPSL.Interfaces.PwPin | p2 |
Components
| Type | Name | Default | Description |
|---|---|---|---|
| OpenIPSL.Electrical.SystemBase | SysData (from ThreePhaseComponent) | Must add this line in all models | |
| Types.PerUnit | V1 | Bus voltage magnitude for phase 1 | |
| Types.Angle | angle1 | Bus voltage angle for phase 1 | |
| Types.PerUnit | V2 | Bus voltage magnitude for phase 2 | |
| Types.Angle | angle2 | Bus voltage angle for phase 2 |