.SiemensPower.Boundaries.Reservoir

Information

This model allows a specified amount of heat flow rate to be "injected" into a thermal system or specify a certain temperature reservoir.
In case of a heat reservoir, the amount of heat at each cell is given by Q0/N.
The heat flows into the component to which the component PrescribedHeatFlow is connected, if the input signal is positive.

Author: Haiko Steuer SCD
Checked by:
Protection class:
Used Dymola version:
Copyright © 2007 Siemens AG, PG EIP12. All rights reserved.

This model is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY. For details see disclaimer

Revisions


Generated at 2024-05-20T18:15:57Z by OpenModelicaOpenModelica 1.22.4 using GenerateDoc.mos