modelTraditional

Traditional: Cylinder with spherical caps

Extends from TRANSFORM.Fluid.Volumes.BaseClasses.BaseDrum.DrumTypes.PartialDrumType.

Information

A traditional pressurizer geometry with two spherical caps and a cylindrical middle body.

The surface area associated with the wall is calculated as the outer surface of the three regions. In other words,

if the radii are not the same, the calculation does not calculate the differences into the surface area calculation although

it is factored into the volume and therefore the liquid level calculation.

Parameters

TypeNameDefaultDescription
SI.VolumeV_total_parameter (from PartialDrumType)1Needs to be re-set by extending class
Region 1: Bottom Spherical Cap
SI.Lengthr_1Region 1 radius
Region 2: Middle Cylinder
SI.Lengthr_2Region 2 radius
SI.Heighth_2Region 2 height
Region 3: Top Spherical Cap
SI.Lengthr_3Region 3 radius

Components

TypeNameDefaultDescription
TRANSFORM.Units.NonDimVfrac_liquid (from PartialDrumType)Fractional of total volume occupied by liquid
SI.VolumeV_liquid (from PartialDrumType)Volume of liquid
SI.VolumeV_vapor (from PartialDrumType)Volume of vapor
SI.VolumeV_total (from PartialDrumType)Total pressurizer volume
SI.Heightlevel (from PartialDrumType)Measured fluid level
RealRegion (from PartialDrumType)Liquid-Vapor surface location region identifier
SI.AreaA_surfaceWTotal (from PartialDrumType)Total inner wall surface area of pressurizer
SI.AreaA_surfaceWL (from PartialDrumType)Wall-Liquid interfacial area
SI.AreaA_surfaceWV (from PartialDrumType)Wall-Vapor interfacial area
SI.AreaA_surfaceVL (from PartialDrumType)Vapor-Liquid interfacial area