.Annex60.Fluid.Sensors.SpecificEnthalpyTwoPort

Information

This model outputs the specific enthalpy of a passing fluid. The sensor is ideal, i.e. it does not influence the fluid. If the parameter tau is non-zero, then its output is computed using a first order differential equation. Setting tau=0 is not recommend. See Annex60.Fluid.Sensors.UsersGuide for an explanation.

Revisions

• January 18, 2016 by Filip Jorissen:
  Using parameter tauInv since this now exists in Annex60.Fluid.Sensors.BaseClasses.PartialDynamicFlowSensor. This is for #372.
• June 3, 2011 by Michael Wetter:
  Revised implementation to add dynamics in such a way that the time constant increases as the mass flow rate tends to zero. This significantly improves the numerics.
• September 29, 2009, by Michael Wetter:
  First implementation.