.BuildingSystems.Fluid.FMI.Validation.HeaterFan

Information

This example demonstrates how to configure a model with a heater and a fan that causes a pressure rise in the air stream. Note that the mass flow rate and the absolute pressure are set by the component sou. Therefore, the fan simply increases the pressure of the medium, and it also computes how much power is needed for this pressure rise, which is an input to the fan model.

For a model with that computes the mass flow rate based on the pressure drop, see BuildingSystems.Fluid.FMI.Validation.HeaterFanPressureDriven.

For this example, the models are not exported as FMUs. However, the thermofluid flow models are wrapped using input/output blocks.

Contents

Name	Description
Medium	Medium model

Revisions

• January 22, 2016, by Michael Wetter:
  Corrected type declaration of pressure difference. This is for #404.
• November 8, 2014, by Michael Wetter:
  First implementation.