recordGenericAirToWater
Partial record for air-to-water heat pump devices
Extends from GenericHeatPump (Partial heat pump data).
Information
This record allows specific selection using
choicesAllMatching for air-to-water heat pumps only in models such as
BuildingSystems.Fluid.HeatPumps.ModularReversible.AirToWaterTableData2D.
Parameters
| Type | Name | Default | Description |
|---|---|---|---|
| Real[:,:] | tabPEle (from Generic) | Electrical power consumption table, T in K, Q_flow in W | |
| Modelica.Units.SI.MassFlowRate | mCon_flow_nominal (from Generic) | Nominal mass flow rate in condenser | |
| Modelica.Units.SI.MassFlowRate | mEva_flow_nominal (from Generic) | Nominal mass flow rate in evaporator | |
| Modelica.Units.SI.PressureDifference | dpCon_nominal (from Generic) | Nominal pressure drop in condenser | |
| Modelica.Units.SI.PressureDifference | dpEva_nominal (from Generic) | Nominal pressure drop in evaporator | |
| String | devIde (from Generic) | Name of the device | |
| Boolean | use_TEvaOutForTab (from Generic) | =true to use evaporator outlet temperature for table data, false for inlet | |
| Boolean | use_TConOutForTab (from Generic) | =true to use condenser outlet temperature for table data, false for inlet | |
| Real[:,:] | tabQCon_flow (from GenericHeatPump) | Heating output table, T in K, Q_flow in W | |
| Real[:,2] | tabUppBou (from GenericHeatPump) | Points to define upper boundary for sink temperature | |
| Boolean | use_TEvaOutForOpeEnv (from GenericHeatPump) | false | =true to use evaporator outlet temperature for operational envelope, false for inlet |
| Boolean | use_TConOutForOpeEnv (from GenericHeatPump) | true | =true to use condenser outlet temperature for operational envelope, false for inlet |
Revisions
-
October 2, 2022 by Fabian Wuellhorst:
Added to enable better selection #1576)