modelTemperatureControlledHeatFlow
Prescribed heat flow boundary condition, depending on a set temperature TSet
Information
This model allows a specified amount of heat flow rate to be "injected" into a thermal system at a given port. The amount of heat is given by the input signal T_set into the model. The heat flows into the component to which the component PrescribedHeatFlow is connected, if the input signal is positive.
Parameters
| Type | Name | Default | Description |
|---|---|---|---|
| Modelica.Units.SI.HeatFlowRate | Q_flow_maxHeat | Maximum heat flow rate for heating (positive) | |
| Modelica.Units.SI.HeatFlowRate | Q_flow_maxCool | Maximum heat flow rate for cooling (negative) |
Connectors
| Type | Name | Default | Description |
|---|---|---|---|
| Modelica.Blocks.Interfaces.RealInput | TSet | Set temperature of the heater | |
| Modelica.Thermal.HeatTransfer.Interfaces.HeatPort_b | port |
Components
| Type | Name | Default | Description |
|---|---|---|---|
| Medium.SpecificEnthalpy | h_outflow | Specific thermodynamic enthalpy | |
| Medium.MassFlowRate | m_flow | Mass flow rate | |
| Modelica.Units.SI.Pressure | p | Pressure | |
| Modelica.Units.SI.MassFraction[Medium.nXi] | Xi | Mass fraction |
Contents
| Name | Description |
|---|---|
 Medium | Medium in the component |