.BuildingSystems.Fluid.Movers.FlowControlled_m_flow

Information

This model describes a fan or pump with prescribed mass flow rate.

Note that if the model operates with a head that is larger than dpMax, which by default is two times larger than the largest head declared in eff.per.pressure.dp, the simulation will stop with an error message. This guards against unreasonably high pressure drops and electrical power use, which can happen if the model is forcing mass flow rate through a closed actuator.

See the User's Guide for more information.

Revisions


Generated at 2024-12-23T19:25:42Z by OpenModelicaOpenModelica 1.24.3 using GenerateDoc.mos