.Buildings.Fluid.Movers.Validation.PumpCurveConstruction

Information

This example tests whether the construction of the pump curve is correct implemented for the cases where no data point is given at zero head, zero mass flow rate, or both.

Each pump is identical, but different points on the pump curve are specified. However, the pump curves are linear and hence, because the pump curves are linearly extrapolated, all four pumps need to give the same flow rate.

Implementation

The pump curves are such that the protected parameter curve of the pumps have different values. This then tests the correct extrapolation.

Contents

Revisions

• December 6, 2016, by Michael Wetter:
  Relaxed input signal to allow simulation if bounds on min and max values are checked in Dymola.
  This is for #606.
• February 20, 2016, by Ruben Baetens:
  Removal of dynamicBalance as parameter for massDynamics and energyDynamics.
• January 22, 2016, by Michael Wetter:
  Corrected type declaration of pressure difference. This is for #404.
• January 7, 2015, by Michael Wetter:
  First implementation.