modelCase695

Diagram of Case695Open the diagram
▶ Simulate in your browser

Extends from Buildings.ThermalZones.ISO13790.Validation.BESTEST.Cases6xx.Case600 (Case 600FF, but with dual-setpoint for heating and cooling).

Information

This model is the case 695 of the BESTEST validation suite. Case 695 differs from case 600 in that it has increased exterior wall and roof insulation and it has single heating and cooling setpoint.

  • Heat = on if zone temperature is below 20°C
  • Cool = on if zone temperature is above 20°C

Components

TypeNameDefaultDescription
Modelica.Blocks.Math.SumsumHeaCoo (from Case600)Sum of heating and cooling heat flow rate
Modelica.Thermal.HeatTransfer.Sources.PrescribedHeatFlowpreHeaCoo (from Case600)Prescribed heat flow for heating and cooling
Modelica.Blocks.Math.GaingaiHea (from Case600)Gain for heating
Buildings.Controls.Continuous.LimPIDconHeaPID (from Case600)Controller for heating
Modelica.Blocks.Sources.CombiTimeTableTSetHea (from Case600)Setpoint for heating
Modelica.Blocks.Routing.Multiplex2multiplex2 (from Case600)
Modelica.Blocks.Math.GaingaiCoo (from Case600)Gain for cooling
Buildings.Controls.Continuous.LimPIDconCooPID (from Case600)Controller for cooling
Modelica.Blocks.Continuous.IntegratorECoo (from Case600)Cooling energy in Joules
Buildings.ThermalZones.ISO13790.Zone5R1C.ZoneHVACzonHVAC (from Case600)
Modelica.Blocks.Sources.ConstantintGai (from Case600)Internal heat gains
Buildings.BoundaryConditions.WeatherData.ReaderTMY3weaDat (from Case600)Weather data
Modelica.Blocks.Continuous.IntegratorEHea (from Case600)Cooling energy in Joules
Buildings.Controls.OBC.CDL.Reals.MovingAveragePHea (from Case600)Hourly averaged heating power
Buildings.Controls.OBC.CDL.Reals.MovingAveragePCoo (from Case600)Hourly averaged cooling power
Modelica.Blocks.Sources.CombiTimeTableTSetCoo (from Case600)Setpoint for cooling
Modelica.Blocks.Sources.ConstantlatGai (from Case600)Internal heat gains

Revisions

  • May 3, 2024, by Alessandro Maccarini:
    First implementation.