| Modelica.Units.SI.Temperature | initT | 473.15 | initial temperature of the vessel |
| Modelica.Units.SI.ThermalInsulance | foulingF | | process side fouling factor |
| Modelica.Units.SI.Height | hLiquid | | liquid height from bottom |
| Boolean | useHTWallCorr | true | use, or not, wall viscosity correction for heat transfer |
| Modelica.Units.NonSI.AngularVelocity_rpm | n | | mixer shaft rotational speed rpm |
| Modelica.Units.SI.Power | distPower | 0.0 | power needed for distillation |
| Thermal fluid 1 |
| FreeFluids.Types.SourceOption | TF1Option | FreeFluids.Types.SourceOption.useP_T | themo fluid 1 enthalpy calculation option |
| Modelica.Units.SI.Temperature | TF1initT | 553.15 | initial temperature of the thermal fluid 1 |
| Modelica.Units.SI.AbsolutePressure | TF1initP | 9.0e5 | initial pressure of the thermal fluid 1 |
| Modelica.Units.SI.SpecificEnthalpy | TF1initH | if TF1Option == FreeFluids.Types.SourceOption.useP_T then Medium1.specificEnthalpy(Medium1.setState_pTX(TF1initP, TF1initT)) else Medium1.specificEnthalpy(Medium1.setState_pTX(Medium1.p_default, Medium1.T_default)) | initial enthalpy of the thermal fluid 1. Leave it unchanged |
| Modelica.Units.SI.SpecificEnthalpy | TF2initH | if TF2Option == FreeFluids.Types.SourceOption.useP_T then Medium2.specificEnthalpy(Medium2.setState_pTX(TF2initP, TF2initT)) else Medium2.specificEnthalpy(Medium2.setState_pTX(Medium2.p_default, Medium2.T_default)) | initial enthalpy of the thermal fluid 2. Leave it unchanged |
| Thermal fluid 2 |
| FreeFluids.Types.SourceOption | TF2Option | FreeFluids.Types.SourceOption.useP_T | |
| Modelica.Units.SI.Temperature | TF2initT | 553.15 | initial temperature of the thermal fluid 2 |
| Modelica.Units.SI.AbsolutePressure | TF2initP | 9.0e5 | initial pressure of the thermal fluid 2 |
Medium1