| Modelica.Units.SI.Temperature | TRoo_nominal (from Partial_Ctrl_Heating) | 273.15 + 21 | Room temperature at nominal condition |
| Modelica.Units.SI.Temperature | TSupNom (from Partial_Ctrl_Heating) | | Nominal heating curve supply temperature |
| Modelica.Units.SI.TemperatureDifference | dTSupRetNom (from Partial_Ctrl_Heating) | 10 | Nominal difference between supply and return water temperatures |
| Modelica.Units.SI.TemperatureDifference | dTHeaterSet (from Partial_Ctrl_Heating) | 2 | Difference between heating curve setpoint and heater setpoint |
| Modelica.Units.SI.Time | timeFilter (from Partial_Ctrl_Heating) | 43200 | Time constant for filter on ambient temperature |
| Modelica.Units.SI.Temperature | TSupMin (from Partial_Ctrl_Heating) | 273.15 + 30 | Minimum supply temperature if enabled |
| Boolean | minSup (from Partial_Ctrl_Heating) | true | true to limit the supply temperature on the lower side |
| Modelica.Units.SI.TemperatureDifference | dTOutHeaBal (from Partial_Ctrl_Heating) | 0 | Offset for heating curve |
| Modelica.Units.SI.Temperature | TOut_nominal (from Partial_Ctrl_Heating) | 273.15 - 8 | Outside temperature |
| Modelica.Units.SI.TemperatureDifference | corFac_val (from Partial_Ctrl_Heating) | 0 | correction term for TSet of the heating curve |
| Modelica.Units.SI.TemperatureDifference | dTSafetyTop | 3 | Safety margin on top temperature setpoint |
| Modelica.Units.SI.TemperatureDifference | dTSafetyBot | dTSafetyTop | Safety margin on bottom temperature setpoint |
| Modelica.Units.SI.TemperatureDifference | dTHPTankSet | 2 | Difference between tank setpoint and heat pump setpoint |
| Boolean | DHW | true | if true, the system has to foresee DHW |
| Modelica.Units.SI.Temperature | TDHWSet | 273.15 + 60 | Setpoint temperature for the DHW outlet |
| Modelica.Units.SI.Temperature | TColdWaterNom | 273.15 + 10 | Nominal tap (cold) water temperature |
