.BuildingSystems.Electrical.AC.ThreePhasesUnbalanced.Loads.BaseClasses.BaseLoadCtrl

Information

This model represents a partial interface for a three-phase AC unbalanced load.

The loads on each phase can be removed using the boolean flags plugPhase1, plugPhase2, and plugPhase3. These parameters can be used to generate unbalanced loads.

The loads can be connected either in wye (Y) or delta (D) configuration. The parameter loadConn can be used for such a purpose.

Each load model has the option to be controlled by a voltage controller. When enabled, the voltage controller unplugs the load for a certain amount of time if the voltage exceeds a given threshold. Mode information about the voltage controller can be found here.

Revisions

• September 17, 2016, by Michael Wetter:
  Corrected wrong annotation to avoid an error in the pedantic model check in Dymola 2017 FD01 beta2.
  This is for issue 557.
• February 26, 2016, by Michael Wetter:
  Added adapters for issue 426.
• September 24, 2015 by Michael Wetter:
  Provided value for P_nominal if mode <> BuildingSystems.Electrical.Types.Load.VariableZ_P_input. This avoids a warning during translation of BuildingSystems.Electrical.AC.ThreePhasesUnbalanced.Loads.Inductive.
• September 24, 2014, by Marco Bonvini:
  Created model and documentation.