This package contains base classes that are used to construct the models in Buildings.Fluid.DXSystems.Cooling.
| Name | Description |
|---|---|
| ApparatusDewPoint | Calculates air properties at apparatus dew point |
| ApparatusDryPoint | Calculates air properties at dry coil surface |
| CapacityWaterCooled | Calculates cooling capacity at given temperature and flow fraction for water source DX coils |
| Condensation | Calculates rate of condensation |
| DXCooling | DX cooling coil operation |
| DryWetSelector | Selects results from dry or wet coil |
| EssentialParameters | A partial block for essential parameters for cooling DX coils |
| Evaporation | Model that computes evaporation of water that accumulated on the coil surface |
| InputPower | Electrical power consumed by the unit |
| PartialCapacity | Calculates performance curve value at given temperature and mass flow rate |
| PartialCoilCondition | Partial block for dry and wet coil conditions |
| PartialCoilInterface | Partial block for DX coil |
| PartialDXCoil | Partial model for air or water cooled DX cooling coil |
| PartialDXCoolingCoil | Partial model for DX cooling coil |
| PartialSurfaceCondition | Partial block for apparatus dew and dry point calculation |
| PartialWaterCooledDXCoil | Base class for water source DX coils |
| SensibleHeatRatio | Calculates the sensible heat ratio |
| SpeedSelect | Selects the lower specified speed ratio for multispeed model |
| SpeedShift | Interpolates values between speeds |
| UACp | Calculates UA/Cp of the coil |
| WetCoil | Calculates wet coil condition |
| Functions | Package with functions |
| Examples | Collection of models that illustrate model use and test models |