This package contains validation models for the classes in Buildings.Fluid.MixingVolumes.

Note that most validation models contain simple input data which may not be realistic, but for which the correct output can be obtained through an analytic solution. The examples plot various outputs, which have been verified against these solutions. These model outputs are stored as reference data and used for continuous validation whenever models in the library change.

Name | Description |
---|---|

CoupledVolumesAir | Validation model for two coupled volumes with air |

CoupledVolumesGlycol47 | Validation model for two coupled volumes with glycol |

CoupledVolumesSpecializedAirPerfectGas | Validation model for two coupled volumes with air as a perfect gas |

CoupledVolumesSpecializedWaterConstantProperties_pT | Validation model for two coupled volumes with water with constant properties |

CoupledVolumesSpecializedWaterTemperatureDependentDensity | Validation model for two coupled volumes with water with temperature dependent density |

CoupledVolumesWater | Validation model for two coupled volumes with water |

MixingVolume | Test model for mixing volumes |

MixingVolumeAdiabaticCooling | Validation model for mixing volume with adiabatic cooling |

MixingVolumeHeatReverseFlow | Validation model for mixing volume with heat input and flow reversal |

MixingVolumeHeatReverseFlowPrescribedHeatFlowRate | Validation model for mixing volume with heat input and flow reversal and prescribed heat flow rate |

MixingVolumeInitialization | Test model for mixing volume initialization |

MixingVolumeMFactor | A check for verifying the implementation of the parameter mSenFac |

MixingVolumeMassFlow | Test model for mass flow into and out of volume |

MixingVolumeMoistureReverseFlow | Validation model for mixing volume with moisture input and flow reversal |

MixingVolumeMoistureReverseFlowPrescribedHeatFlowRate | Validation model for mixing volume with moisture input and flow reversal and prescribed heat flow rate |

MixingVolumeSteadyStateMass | Test model for steady state mass dynamics |

MixingVolumeTraceSubstance | Test model for mixing volume with trace substance input |

MixingVolumeTraceSubstanceReverseFlow | Validation model for mixing volume with trace substance input and flow reversal |

MixingVolumeTraceSubstanceReverseFlowPrescribedHeatFlowRate | Validation model for mixing volume with trace substance input and flow reversal, and prescribed heat flow rate |

MixingVolumeZeroFlow | Mixing volume verification around zero flow with heat exchange |

MoistureMixingConservationDynamicBalance | This test checks if mass and energy is conserved when mixing fluid streams using dynamic balances |

MoistureMixingConservationSteadyState | This test checks if mass and energy is conserved when mixing fluid streams using steady state balances |

TraceSubstanceConservationDynamicBalance | This test checks if trace substance mass flow rates are conserved when a dynamic balance is used |

TraceSubstanceConservationSteadyState | This test checks if trace substance mass flow rates are conserved when steady state |

BaseClasses | Baseclasses package |

Generated at 2021-04-18T01:03:03Z by OpenModelicaOpenModelica 1.18.0~dev-228-gf450566 using GenerateDoc.mos