.Buildings.Fluid.Sensors.Density

Information

This model outputs the density of the fluid connected to its port. The sensor is ideal, i.e. it does not influence the fluid.

To measure density in a duct or pipe, use Buildings.Fluid.Sensors.DensityTwoPort rather than this sensor. Read the Buildings.Fluid.Sensors.UsersGuide prior to using this model to see about potential numerical problems if this sensor is used incorrectly in a system model.

Revisions


Generated at 2024-03-27T19:15:56Z by OpenModelicaOpenModelica 1.22.3 using GenerateDoc.mos