.Buildings.Fluid.Sensors.RelativeTemperature

Information

The relative temperature T(port_a) - T(port_b) is determined between the two ports of this component and is provided as output signal. The sensor should be connected in parallel with other equipment. There is no flow through the sensor.

Note that this sensor should only be connected to fluid volumes, such as Buildings.Fluid.MixingVolumes.MixingVolume. Otherwise, numerical problems may occur if one of the mass flow rates are close to zero. See Buildings.Fluid.Sensors.UsersGuide for an explanation.

Contents

Revisions

• February 25, 2020, by Michael Wetter:
  Changed icon to display its operating state.
  This is for #1294.
• January 18, 2019, by Jianjun Hu:
  Limited the media choice. See #1050.
• September 29, 2009, by Michael Wetter:
  First implementation, based on Modelica.Fluid.