.Buildings.Fluid.Sensors.SpecificEnthalpy

Information

This model outputs the specific enthalpy of the fluid connected to its port. The sensor is ideal, i.e. it does not influence the fluid.

To measure specific enthalpy in a duct or pipe, use Buildings.Fluid.Sensors.SpecificEnthalpyTwoPort rather than this sensor. Read the Buildings.Fluid.Sensors.UsersGuide prior to using this model to see about potential numerical problems if this sensor is used incorrectly in a system model.

Revisions

• September 21, 2020, by Michael Wetter:
  Introduced parameter warnAboutOnePortConnection and updated documentation.
  This is for #1399.
• February 25, 2020, by Michael Wetter:
  Changed icon to display its operating state.
  This is for #1294.
• September 29, 2009, by Michael Wetter:
  First implementation.