.Buildings.Fluid.Sources.TraceSubstancesFlowSource

Information

This model can be used to inject trace substances into a system. The model adds a mass flow rate to its port with a trace substance concentration of 1.

Typical use and important parameters

A typical use of this model is to add carbon dioxide to room air, since the carbon dioxide concentration is typically so small that it need not be added to the room mass balance, and since the mass flow rate can be made small compared to the room volume if the medium that leaves this component has a carbon dioxide concentration of 1. The parameter substanceName must be set to the name of the substance that is injected into the fluid.

Note however that mixing volumes from the package Buildings.Fluid.MixingVolumes allow to directly add a trace substance mass flow rate, which is more efficient than using this model.

Contents

NameDescription
MediumMedium in the component

Revisions


Generated at 2024-03-28T19:15:55Z by OpenModelicaOpenModelica 1.22.3 using GenerateDoc.mos